| Dernières réponses | |  To connect a WOpet feeder to Wi-Fi, download the correct app, put the feeder in pairing mode by holding the Wi-Fi button until the indicator light flashes rapidly (usually red or green), and then follow the in-app instructions to select your 2.4 GHz network and enter the password.
[b]Before you begin[/b]
[list]
[b]Download the app:[/b] Find the correct app for your model by checking the user manual, which can be downloaded from the WOpet website.
[b]Find your network information:[/b] Make sure you have the password for your Wi-Fi network.
[b]Check your Wi-Fi band:[/b] WOpet feeders only support 2.4 GHz networks. If your phone is connected to a 5 GHz network, switch to a 2.4 GHz network before starting.
[/list]
[b]Step-by-step connection[/b]
[list=1]
[b]Put the feeder in pairing mode:[/b]
[list]
Press and hold the Wi-Fi or SET button on the feeder for about 3-5 seconds until you hear a beep and the indicator light starts flashing rapidly (this may be red or green depending on the model).
If you see a pop-up in the app, confirm that the indicator light is flashing rapidly and tap "Next" or "Indicator is flashing rapidly".
[/list]
[b]Select your network and enter the password:[/b]
[list]
Allow the app to access your location if prompted, which should automatically display your Wi-Fi network name.
Ensure the correct 2.4 GHz network is selected.
Enter your Wi-Fi password and tap "Confirm" or "Next".
[/list]
[b]Complete the connection:[/b]
[list]
The feeder will now attempt to connect. This may take a few moments.
Some models may use a QR code that you need to show to the feeder's camera until you hear a beep.
Once connected, the indicator light will change, and you may be prompted to give your feeder a name in the app.
[/list]
[/list]
[b]Troubleshooting[/b]
[list]
[b]If the connection fails:[/b] Ensure you are on a 2.4 GHz network and have entered the correct password. You may need to use a different connection method, like AP mode, which is sometimes called "hotspot connection" in the app.
[b]If the light isn't flashing correctly:[/b] Long-press the Wi-Fi button again to reset the pairing mode until the light flashes rapidly.
[/list] |
|
|